Admix PU700

High Performance Single Component Polyurethane Sealant


ADMIX PU700 is a single component flexible sealant based on polyurethane resin which needs no mixing. The product is supplied in easy to use cartridges.


ADMIX PU700 has excellent flexibility and has ability to withstand repeated compaction or recover (up to 25%). The product has excellent resistance to environmental temperature and does not harden nor soften in temperature between -30 to +80°C. It has excellent UV resistance and can be used for outdoor application. 

Technical Data

Density: Approx. 1.3 g/cm³ at 25°C
Application Temperature: +5 to +35°C
Curing time: 2 mm in 24 hours
Skin formation: 1.5 hours at 20°C
Permanent expansion capacity: 25%
Thermal resistance: -30 to +80°C
Elongation: Up to 600%
Modulus of elasticity: 0.25 MPa

Surface preparation
Surface should be sound, stable, clean and free from paint, oil, grease, contamination and dust. Removing laitance and grout is very important. In general, tensile strength of concrete surface should be 1.5 MPa. For the joint sealant proper function, it is essential that bond breaker tape or polyethylene closed cell backer rod be used to regulate joint depth and prevent three sided adhesion.

Joint design
To ensure long term performance, the depth of the joint should be designed to be approximately half of the width especially on joints >25mm wide.

On well prepared dry, sound concrete older than 28 days, masonry, metal or glass surfaces primer is not required. Metal surfaces should not be greasy.

ADMIX PU700 is supplied as a ready to use product. Cut one end of the foil and place it in a manual or pneumatic gun and apply immediately. The product should be tooled smooth with a spatula and non-alcoholic liquid to create a concave surface free of bubbles. It can be applied directly both horizontally and vertically.

Note: Before applying sealant, joint surrounding area must be covered by paper tape. Clean the surfaces immediately after completion of the job.

ADMIX PU700 is supplied in 600 ml cartridges.

ADMIX PU700 must be stored under cover out of direct sunlight and protected against rainfall and moisture at normal temperature. Shelf life is 12 months if stored in stated condition.

Safety awareness
Like other chemical materials, ADMIX PU700 may cause irritation. In case of any contact with eyes or skin, wash it immediately with clean water for at least 15 minutes and get medical helps. Use personal safety devices such as gloves, goggles, and safety dress while working with this product.

Equipment carefulness
Tools and equipment should be washed with suitable solvents at the end of each phase of the job or before break time.

Quality approval

All materials produced in White Damavand Co. are under strict control of QC department and meet the requirements of international standards.

For additional information, contact company’s specialists in Tehran at: 88678881-3 or email address: