Admix BM730

Application method
ADMIX BM730 can be applied by means of a putty knife or trowel. Surface preparation is very important. All surfaces should be sound, stable, clean and free from paint, oil, grease, contamination and dust. This product is supplied in ready to use paste form and needs no primer. For better bonding, clean and harsh inside of the joints using sand paper or sandblasting. Sealant can be applied on damp surfaces, but no standing water should exist.

Note: While filling joints, make sure that depth of the joint not be greater than its width. Fill the extra depth of the joint with suitable joint filler to reach proper dimensions.

Equipment carefulness
Tools and equipment should be washed with solvent before drying. Cured materials can be removed mechanically and then be cleaned by paraffin.

Packaging
ADMIX BM730 is supplied in 12 kg pails and 220 kg drums.

Storage
ADMIX BM730 must be stored in original containers on pallets out of direct sunlight and extreme of temperature. The product is flammable and should avoid any ignition or fire while storage. Shelf life is 12 months.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage condition contact White Damavand Technical Services Department.

Safety awareness
Like other chemical materials, special care is needed during storage and use of ADMIX BM730. Avoid smoking or ignition or any contact with eyes, mouth, skin or foodstuffs. In case of any contact with eyes or skin, wash it immediately with clean water for at least 15 minutes and get medical helps. For more information about safety, please read product material safety data sheet.