Admix PC781

Surface preparation
Surface to be protected, should be dry and free from loose laitance. Clean any contamination, paint, oil, grease, mold release agent, residual curing compound and plaster by means of dry brushing or sand blast. Minor moisten substrate is allowed but running water should not exists. Before applying coating, repair and level surfaces by a suitable repair mortar to avoid excess use of coating and providing fair finishing.

Applying
ADMIX PC781 is supplied as a ready to use product and needs well stirring before use. If necessary it can be diluted with small amount of water. Apply a thin layer of primer on prepared surfaces to fix any loose particles. Final application can be done by means of brush, roller or low pressure sprayer in two coats to make sure that the surface is fully covered.

Coverage
For coverage of 1 square meter, 100 to 150 grams primer and 250 to 300 grams ADMIX PC781 is needed, which depends on surface roughness. Lack of surface preparation may result in excess consumption of product.

Equipment carefulness
Wash the tools and equipment with water after completion of each phase of application or before break times.

Storage
This product must be stored in original containers on pallets out of direct sunlight at temperature above +5C°,It is not refundable after frozen and should not be used. Shelf life is 12 months.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product. For specific storage condition contact Damavand Sefid Technical Services Department.

Safety awareness
ADMIX PC781 does not contain any hazardous substances but like other chemical products, use personal safety devices when working with this product. For more information about safety, read material safety data sheet.